Lavorwash ODM-R Manuel D'instructions page 6

the connector on the machine base.
Inst alling the brush/disc driv er/disc:
1. Pull the handle height adjustment lever and raise the handle to the upright position.
tip the machine backwards and rest the handle on the floor.
2. To attach the disc, centre the disc driver on the disc and push with your hand to fix it in place.
3. Position the disc driver/brush on the motor shaft and turn clockwise to fix in place.
4. Place the machine upright again.
Det ergent s - Inst ruct ions:
If the machine has a water/detergent tank, this must be filled with no more than 11 litres.
Always dilute the detergent according to the manufacturer's instructions. Do not use solvents or
hydrocarbons.
Perform the first test wash with a small quantity of water/detergent.
quantity of water/detergent until the required washing result is obtained.
M aint enance:
1. Remove and clean the disc drive/brush after each cleaning session.
2. After each cleaning session, check the power cable for damage. If damaged, under no
circumstances should the machine be used. Contact a service centre to have the cable
replaced.
3. Check regularly that all bolts and nuts are tight.
St oring:
1. Remove the brush/disc driver from the machine and neatly wind the cable around the
cable hook and handle.
2. Store machine upright in a dry place.
Fuse, cont rol/replacement:
1. Stop the machine
2. Disconnect the machine from the electricity supply.
3. Check the fuse and if necessary replace.
.
2
ENGLISH (Translation of original instructions
Carefully
Gradually increase the
)