Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
18 electrolux
Installation Instructions
1
Safety instructions
Warning! This must be read!
The laws, ordinances, directives and stand-
ards in force in the country of use are to be
followed (safety regulations, proper recycling
in accordance with the regulations, etc.)
Installation may only be carried out by a qual-
ified electrician.
The minimum distances to other appliances
and units are to be observed.
Anti-shock protection must be provided by
the installation, for example drawers may
only be installed with a protective floor direct-
ly underneath the appliance.
The cut surfaces of the worktop are to be
protected against moisture using a suitable
sealant.
The sealant seals the appliance to the work
top with no gap.
When building in, protect the underside of
the appliance from steam and moisture, e.g.
from a dishwasher or oven.
Avoid installing the appliance next to doors
and under windows. Otherwise hot cook-
ware may be knocked off the rings when
doors and windows are opened.
z
Risk of injury from electrical
current.
•
The electrical mains terminal is live.
•
Make electrical mains terminal free of
voltage.
•
Follow connection schematic.
•
Observe electrical safety rules.
•
Ensure anti-shock protection by install-
ing correctly.
•
The appliance must be connected to the
electrical supply by a qualified electri-
cian.
z
Risk of injury from electrical
current.
•
Loose and inappropriate plug and sock-
et connections can make the terminal
overheat.
•
Have the clamping connections correct-
ly installed by a qualified electrician.
•
Use strain relief clamp on cable.
•
In the event of single-phase or two-
phase connection, the appropriate
mains cable of type H05BB-F Tmax
90°C(or higher) or an equivalent type
must be used.
•
If this appliance's mains cable is dam-
aged, it must be replaced by a special
cable (type H05BB-F Tmax 90°C; or
higher) or an equivalent type. The latter
is available from the Customer Care De-
partment.
A device must be provided in the electrical
installation which allows the appliance to be
disconnected from the mains at all poles with
a contact opening width of at least 3 mm.
Suitable isolation devices include line pro-
tecting cut-outs, fuses (screw type fuses are
to be removed from the holder), earth leak-
age trips and contactors.
Sticking on the seal
•
Clean the worktop around the cut-out
area.
•
Stick the single-sided adhesive sealing
tape provided on the underside of the
hob around the outside edge ensuring
that it is not stretched. The two ends of
the tape should join in the middle of one
side. After trimming the tape (allow it to
overlap by 2-3 mm), press the two ends
together.
Publicité
Table des Matières
