Pentair Magicstream Deckjet II Guide De L'installation page 3

INSTALLATION
The Deck Jet body is designed to be connected to a 3/4" Sch 40 PVC Pipe. An adaptor is included
to convert this to a 25mm metric PVC pipe (Figure 2). After the pipe is pressure tested, solvent
weld the Deck Jet body to the 3/4" or 25mm supply pipe.
Anchor the Deck Jet body, with the Deck Jet cover attached, so the cover is level with the finished
deck surface.
Figure 2
Once the deck is finished, flush any debris from the supply pipe using the pump and filter system that supplies the Deck
jet. Apply Teflon® tape to the threads of the swivel base.Remove any debris from the cup and screw the swivel base into
the Deck Jet body (Figure 2). By Hand, puch the swivel nozzle until it snaps onto the swivel base (Figure 3).
Operation
Start the pump and adjust the appropriate valves as necessary to create the desired water effect.If the stream of water
is disrupted, remove the Deck Jet cover, Jet and Jet Swivel Base. Check to see of there is any debris blocking the Jet.
To winterize, remove the Jet and Jet Swivel Base. Blow the lines clear with air, and install a 1/2" threaded plug.
LIMITED wArrANTy: 2 yEArS
© 2012 Pentair. All rights reserved.
This document is subject to change without notice.
Trademarks and Disclaimers :
MagicStream® and Pentair® are trademarks and/or registered trademarks of Pentair and/or its affiliated companies in the United
States and/or other contries. Teflon® is a registered trademark of E.I. Du Pont De Nemours and Company Corporation. Unless noted,
names and brands of others that may be used in this document are not used to indicate an affiliation or endorsement between the
proprietors of these names and brands and Pentair. Those names and brands may be trademarks or registered trademarks of those
parties and others.
NOTE : Use PVC/ABS glue only !
Swivel base
Attach Teflon tape to the swivel
base and screw the swivel base
into the Deck Jet body
¾" Sch40 with 25mm
adaptor for PVC pipe
slip connection
Solvent weld adaptor to pipe, and
Deck Jet to adaptor.
¾" or 25mm
supply pipe
Figure 3
Swivel nozzle
By hand, push the swivel
nozzle on to the swivel base
until it snaps into place
Swivel base
3