Product Description - LightPro 211L Manuel De L'utilisateur

LED Strip and Connector
User manual
Thank you for buying the Lightpro LED Strip and
Connector. This document contains the required
information for correct, efficient, and safe use of the
product. Consult the user manual of your transformer
for more information about the set up and connection of
your light plan or visit our website www.lightpro.nl.
Read the information in this manual carefully before
using the product. Keep this manual near the product for
consultation in the future.

PRODUCT DESCRIPTION

The Lightpro LED Strip is a lighting chain for outdoor
use. The strip can be cut to the desired length before
installation. Attention: before cutting, read the
instructions in this manual carefully!
This product can be used as outdoor lighting in
combination with the Lightpro 12 Volt system. Improper
use of the product can have consequences for the safety,
warranty, and correct functioning of the product and/or
other parts of the system.
SPECIFICATIONS LED STRIP
Article number
Power (per meter)
Luminous flux (per meter) 80­100lm
Protection class
Ambient temperature
Dimmable
Input
SPECIFICATIONS LED STRIP CONNECTOR
Article number
Maximum Power
Afmetingen (l x b x h)
Protection class
Ambient temperature
Cable length
Input
IP67
175L
2,2W
IP67
­20°C to 50°C
No
12V (only with 211L Connector)
176L
36W
1m x 28mm x 28mm
IP44 + IP67
­20°C to 50°C
1m
12V AC/DC
IP44
USE
Packaging content
[Figure A]
1. LED Strip Connector
2. Sealing rubber
3. End cap
4. F­Connector (Article number 137A)
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl
AVAILABLE SEPARATELY
[Figure B]
1. LED Strip (Article number 175L)
CUTTING
[Figure C]
The LED Strip can be cut to any desired length. Cut
through in one movement from the transparent side.
Carefully follow these instructions when cutting the
strip:
1. The LED Strip has been marked with the print DO NOT
CUT HERE. Never cut in this part of the strip.
2. The strip can be shortened as desired. The part of the
strip that is connected to the connector has to have at
least one marking.
3. Short (remaining) parts of the LED Strip which do not
have a marking will not light when connected to the
connector.
4. It is possible that a small part of a few centimetres at
the end of the strip will not light up after cutting.
ASSEMBLE
[Figure D]
1. Unscrew the screw cap and move it to the back.
The LED Strip has to be connected in the right
direction to the connector. When connecting, pay
attention to the direction of the arrow with the print
CONNECTOR. The arrow points in the direction of the
connector.
2. Place the sealing rubber at around 5 cm on the LED
Strip.
3. Connect the LED Strip to the Connector. Make sure the
pins in the connector make proper contact with
the conductors in the strip.
4. Press the sealing rubber to the connector.
5. Place the screw cap on the connector and tighten
properly.
6. Place the end cap at the end of the LED Strip.
7