Table des Matières
Publicité
GB
LED Strip and Connector
User manual
Thank you for buying the Lightpro LED Strip and Con-
nector. This document contains the required informa-
tion for correct, efficient, and safe use of the product.
Consult the general manual of the Lightpro 12-volt
system and the user manual of your transformer for
more information about the set up and connection of
your light plan.
Read the information in this manual carefully before
using the product. Keep this manual near the product
for consultation in the future.
PRODUCT DESCRIPTION
The Lightpro LED Strip is a lighting chain for outdoor
use. The strip can be cut to the desired length before
installation. Attention: before cutting, read the instruc-
tions in this manual carefully!
This product can be used as outdoor lighting in com-
bination with the Lightpro 12 Volt system. Improper
use of the product can have consequences for the
safety, warranty, and correct functioning of the product
and/or other parts of the system.
Specifications LED Strip
Article number
Power (per meter)
Luminous flux (per meter) 80-100lm
Protection class
Ambient temperature
Dimmable
Specifications LED Strip Connector
Article number
Maximum Power
Afmetingen (l x b x h)
Protection class
Ambient temperature
Cable length
175L
2,2W
IP67
-20°C to 50°C
No
176L
36W
1m x 28mm x 28mm
IP44
-20°C to 50°C
1m
USE
Packaging content
[Figure A]
1. LED Strip Connector
2. Sealing rubber
3. End cap
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl
Available separately
[Figure B]
1. LED Strip (Article number 175L)
2. Lightpro connector (Article number 137A)
CUTTING
[Figure C]
The LED Strip can be cut to any desired length.
Carefully follow these instructions when cutting the
strip:
1. The LED Strip has been marked with the print DO
NOT CUT HERE. Never cut in this part of the strip.
2. The strip can be shortened as desired. The part of
the strip that is connected to the connector has to
have at least one marking.
3. Short (remaining) parts of the LED Strip which do
not have a marking will not light when connected to
the connector.
4. It is possible that a small part of a few centimetres at
the end of the strip will not light up after cutting.
ASSEMBLE
[Figure D]
1. Unscrew the screw cap and move it to the back.
The LED Strip has to be connected in the right
direction to the connector. When connecting, pay
attention to the direction of the arrow with the print
CONNECTOR. The arrow points in the direction of the
connector.
2. Place the sealing rubber at around 5 cm on the LED
Strip.
3. Connect the LED Strip to the Connector. Make sure
the pins in the connector make proper contact with
the conductors in the strip.
4. Press the sealing rubber to the connector.
5. Place the screw cap on the connector and tighten
properly.
6. Place the end cap at the end of the LED Strip.
Publicité
Table des Matières
