Herth+Buss Reanimator 1400 Mode D'emploi page 21

All manuals and user guides at all-guides.com
Operating Instruction
2. Insert the plug of the supplied charger into
the charging socket (2) on the side of the
Reanimator.
3. Insert the plug of the charger into a wall
socket (230 V AC). The pins of the plug
must fit the socket. An improper connec-
tion can cause an electric shock, which
may be fatal. Ensure that the Reanimator
and the charger are placed on a dry, non-
flammable surface.
4. You should not use an extension cable
unless absolutely necessary. Using an un-
suitable extension cable can cause a fire
or an electric shock. If an extension cable
must be used, ensure that:
The pins on the extension cable plug
match those on the charger plug in
quantity, size and shape
The extension cable is correctly wired
and is in an electrically sound condition
The wire diameter is large enough for
the ampere rating (alternating current) of
the charger.
5. During the charging process, the LEDs
continually light up in the following order:
(9), (8) and (7).
Once the Reanimator is fully charged, all
three LEDs will illuminate together.
6. Disconnect the charger from the alternat-
ing current source after charging. Then,
disconnect all connections between the
charger and the Reanimator.
21
95980700
EN