Jean Louis David STEAM PROTECT JLD-201IR Mode D'emploi page 8

seal), see FIG 2.
STEP 4 : Fill the water as shown in FIG 3.
Replace the black rubber seal and ensure it
is secured (should you overfill wipe off any
excess water with a clean cloth).
STEP 5 : Put the water tank back on top
of the Steam Protect as shown in FIG 4.
On the top of the water tank you will see
an arrow. Line this arrow with the other ar-
row that is on the Steam Protect. Insert the
tank on a slight angle with the arrow in first.
Once lined up, click/press into position. See
FIG 5. You will hear a click when it is pro-
perly in place.
STEP 1
PULL THE UNLOCK BUTTON
RELEASE THE WATER TANK
STEP 3
PULL BACK THE BLACK
RUBBER SEAL AND FILL IN
STEP 5
STEAM SETTING
(OFF/MED/HIGH)
STEP 2
RELEASE THE WATER TANK
STEP 4
INSERT THE WATER TANK
INSIDE (FOLLOW DIRECTION
OF THE ARROW)
STEP 6
ON/OFF,
HEAT UP/DOWN BUTTON
9
FIG. 3
FIG. 4
FIG. 5