Publicité
Les langues disponibles
Les langues disponibles
Right hand-side brackets
Fitting kit
- 4 fitting brackets
- 2 Ø6 plastic washers
- 6 Ø5 plastic washers
- 4 « silent block » and steel spacers
- 1 central part
- 1 H 8×10 screw
Assembly
- Place the fitting brackets as indicated on pictures (the tightening torque wrench of the engine casing's
screws is 0,8 Kg/m²)
- Assemble the 3 parts of the belly pan using the 4 BHc 5×15 screws, the 4 Ø5 plastic washers and the 4 M5
Nylock nuts (the central part is placed between the 2 others). Fit the silent block on the belly-pan.
- Place the belly-pan on the motorbike; fit it thanks to the 3 BHc 6×20, 1 BHc 5×15 screw, the 3 Ø6 plastic
washers and 1 Ø5 plastic washer.
Move the gasoline
-
inside the belly-pan, and hold them in position next to the water hose
with the plastic collar.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicules made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal road use.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
and oil flowing hoses in a way that they don't fall
* Place the half-part of the belly pan on the
motorbike in order to well see the fitting points.
FITTING INSTRUCTIONS
Left hand-side brackets
Insert the steel washers between the bracket and the
- 2 BHc 6×20 screws
- 6 BHc 5×15 screws
- 4 M5 Nylock nuts
- 1 Ø6 steel washer
- 1 plastic collar
- 2 aluminium nettings 15×8 cm
« CAUTION »
« BELLY-PAN »
CBF 600 2008 → ∞
Use the H 8×10 screw
engine casing
Publicité
