Tefcold UHD 200-P Mode D'emploi page 16

Indications LED's:
Flashing, indicates that a delay is in progress.
Switched on, indicates that the compressor is activated.
Switched on, indicates that defrosting is activated.
Switched on, indicates that the evaporator fan is activated.
Switched on, indicates that alarm is activated.
Display set temperature:
Press this key and the display will show 'Set', press the key again and the display will
show the set temperature. The display will return to normal reading after 15 sec.
Set new temperature:
Press this key and the display will show 'Set', press the key again and the display will
show the set temperature.
Press this key to increase the value.
Press this key to lower the value.
Press this key to save the new settings. The display will flash with the new value and will
then return to normal reading.
Changing of parameters:
Press this key continuously for 5 seconds to access the list of parameters. The display will
show the number of the parameter, press this key again to get access to the parameter-list.
Press this key to scroll up through the parameter-list.
16