Installation Information - Rehau AWADOCK POLYMER CONNECT Notice De Montage

Installation information:

- Check the set AWADOCK POLYMER CONNECT for completeness.
- Test the main pipe for sewage backup before installation.
- During installation, pay attention to cleanliness.
- Keep the retainer ring dry until the fi nal connection.
- An installation wrench set is necessary for the correct fi xing.
Please fi nd in AWADOCK accessories program. Art.-No. 190497-001.
- Information about diameters and pipe wall thickness are to be tested and compared with the main pipe.
Article number Main pipe/
connecting pipe DN/OD
171551-200
171561-250
171571-315
171581-400
171591-500
171601-630
1
Proceed as follows:
1
Mark the connecting position with a suitable pen (between 90° and 270°), see drawing.
2
Drill the marked place with an 8 mm drill.
3
Insert the centring pin-/borer in the pre-drilled hole. Bore with a keyhole saw a 90° angle off-axis to the pipe.
Hole diameter should be
4
4
Chamfer the drilled section on the inside and outside with a suitable tool.
5
Hold the inside casing as you can see above. We recommend that gloves are worn.
6
Prepare the inside casing at the borehole.
7
Strongly push the inside casing into the borehole.
All manuals and user guides at all-guides.com
Minimum
200/160
250/160
315/160
400/160
500/160
630/160
162 ± 1 mm.
Wall thickness
Maximum
4,9 10,2
6,2 12,7
7,7 15,6
9,8 19,5
12,2 24,1
15,0 33,0
1
5
Material of connecting-
and main pipe
PVC to EN 1401
PP to EN 1852
PP-MD to EN 14758
2
6
3
7
11