Skil DL529301 Guide D'utilisation page 78

d Slide the blade through the slot in the foot and mount it against the inner washer on the shaft.
Be sure that the clamping surfaces of the inner and outer washers lay flush against the blade.
WARNING
e. Reinstall the outer washer. First tighten the blade bolt finger tight, then tighten the blade bolt
1/8 turn (45°) with the hex key (this ensures slippage of the saw blade when it encounters
excessive resistance, thus reducing motor overload and saw kickback).
Fig. 2
Hex Key
Lock-Off Button (Fig.3)
Your tool is equipped with a lock-off button,
located on the handle above the trigger switch.
It reduces the possibility of accidental starting
for personal safety protection.
The lock-off button must be pushed in before
depressing the trigger switch.
14
Make sure that the clamping surfaces of the inner and outer washers
are perfectly clean and face the blade.
Blade Shaft
Inner Washer
Blade
Outer Washer
Blade Bolt
Fig. 3
Trigger Switch
Lower Guard
Lock-Off Button