Step 5: Wiring The Power Supply To Vehicle Battery - weBoost DRIVE X OTR FLEET Guide D'installation

______
Step 5: Wiring The Power
Supply To Vehicle Battery
Use steps below as a draft/template of the general install of
the power supply.
1
Before connecting the power supply, disconnect the vehicle battery
leads to avoid any electrical shocks during installation.
Locate a place where cables are already running through the firewall
2
(rear wall of engine bay) to the inside of the cabin.
3
Locate the same firewall hole from inside of the vehicle cabin.
4
Route the power cables of the power supply from the inside of the
vehicle cabin out through firewall hole.
Note: The cables must be routed inside to outside since the power
supply brick won't fit through the firewall holes. The power supply
brick should remain inside the vehicle cabin.
5
Connect the positive lead of the power supply (lead with red tape)
to the disconnected positive (+) lead of the battery (not the positive
terminal on the battery itself).
6
Connect the negative lead of the power supply (lead without tape)
to the disconnected negative (-) lead of the battery (not the negative
terminal on the battery itself).
7
Connect the positive (+) lead back to the vehicle battery.
8
Connect the negative (-) lead back to the vehicle battery.
NOTE: Having the power supply directly connected to the battery may
drain the battery's life. Please review the vehicle's owner's manual for more
information. Adding a "fuse tap" may be another solution. A "fuse tap" is an
electrical part that functions as a power splitter and is meant to be installed
in the car's fuse box, making the amp shut off when the vehicle's ignition
switch is turned off.
IMPORTANT: Power supply must be wired to fuse.
8
CELL SIGNAL BOOSTER DRIVE X OTR FLEET