For The Installer - komfort WPSK 40 Manuel De L'utilisateur

For the Installer

GENERAL
Komfort WPSK 40 / Komfort WPSK 100 has several
different areas of use.
Komfort WPSK 40 / Komfort WPSK 100 can be used
during external control of the heating system. The
heat pump then charges Komfort WPSK 40 / Kom-
fort WPSK 100 with floating or fixed condensing. The
external control function controls the heat distribu-
tion from Komfort WPSK 40 / Komfort WPSK 100 to
the consumer.
If the flow to the heating system can be restricted
using radiator thermostats, for example, install a
Komfort WPSK 40 / Komfort WPSK 100 as an inter-
mediate tank. This ensures a secure flow for the heat
pump.
Komfort WPSK 40 / Komfort WPSK 100 also allows a
greater flow to the heating system than across the
heat pump.
In some installations, so-called heating clicks occur
as a result of movements during changes in tempe-
rature. To eliminate temporary changes in temperatu-
re, and thereby prevent heating clicks, install a Kom-
fort WPSK 40 / Komfort WPSK 100 after the heating
installation.
Komfort WPSK 40 / Komfort WPSK 100 can also be
used to increase the system volume and thereby pre-
vent malfunctions.
The accumulator tank consists of a condensation-
-insulated steel vessel with polyurethane insulation.
Outer cladding in white, powder-coated sheet metal
with ends of durable plastic.
The accumulator tank is designed and manufactured
for a maximum cut-off pressure of 6 bar.
The working temperature is +4 to +95 °C.
TRANSPORT
Komfort WPSK 40 / Komfort WPSK 100 should be
transported and stored in the dry.
ASSEMBLY
Komfort WPSK 40 / Komfort WPSK 100 has to be in-
stalled vertically suspended on the wall.
The accumulator tank must be installed in a dry area
at a temperature that does not drop below 0 °C (frost-
-free).
Komfort WPSK 40
Komfort WPSK 100
MOUNTING
Komfort WPSK 40 / Komfort WPSK 100 has to be in-
stalled vertically suspended on the wall. First install
the enclosed mounting bracket on the wall, then su-
spend Komfort WPSK 40 / Komfort WPSK 100 from
the bracket.
SUPPLIED COMPONENTS
Suspension bracket.
COMPONENT LOCATION
Komfort WPSK 40 / Komfort WPSK 100
Designa- Name
tion
UL2 Holes for wall bracket
PF3 Serial number plate
PF3
UL2
7