EDM Product 08785 Manuel D'instructions page 21

Cordless jig saw
Operating Instructions
Operation
Never use a blade unsuitable for the task and item to be cut.
Hold the saw in front of you with a firm grip on the handle.
Ensure that the saw blade is not touching anything when
starting the saw. Make sure that the item is clamped tight,
and that the saw line is clearly marked. Connect the vacuum
extractor nozzle to an extractor system where possible.
Start the saw
Place the soleplate on the item, and let the saw blade touch
the saw line. Saw, but do not place more pressure on the
blade than is necessary. Avoid lateral pressure on the blade.
Special notes on jig sawing
Place the base on the item so the saw blade is vertical and
correctly positioned in relation to the saw line without
touching it.
Start the saw and tilt it carefully while supporting it using
the soleplate until the blade touches the item at the saw
line. Levt the blade work through the item, continuing to tip
the saw downwards until the sole is flush to the item and
the blade is perpendicular to it. If necessary, drill a hole of
suitable diameter in the item for use as starting point.
Sawing wood
Check that the item does not contain nails or other metal
objects. Always wear a mask.
Sawing metal
We recommend lubricating the material and saw blade
with cutting oil to protect the tool and avoid overheating.
Support the item with wooden blocks on either side.
Caution! If there's any defective found of the battery pack, it must be repaired
or replaced by the assigned service organization.
Environmental Protection
This product is marked with the selective sorting symbol on waste electrical and electronic equipment. This means
that this product should not be disposed of with household waste but must be supported by a collection system in
accordance with Directive 2012/19/UE. It will then be recycled or dismantled to minimize impacts on the environ-
ment, electrical and electronic products are potentially hazardous to the environment and human health due to the
presence of hazardous substances.
INSTRUCTION MANUAL
EN
Sawing plastic
Make a test cut first to check if the material can tolerate the
heat generated by sawing.
Important! Check all screws on the saw regularly,
particularly those that hold the blade. Tighten if required.
Care and Maintenance
Keep the ventilation openings clear and clean the product
regularly. This machine requires no special mechanical
maintenance such as greasing the bearings.
If something unusual occurs during use, switch off the
supply and remove the battery pack. Inspect and repair the
tool before using it again. The repairs must be carried out by
a qualified technician.
Repair of the tool must only be carried out by a qualified
repair technician.
Repair or maintenance by unqualified personnel can lead to
a risk of injury.
Use only identical spare parts for repairing a tool.
Care and cleaning
Cleaning of plastic parts is disconnected machines, using a
soft damp cloth and a mild soap.
Never immerse the machine and do not use detergent,
alcohol, petrol, etc..
In case of problems or for a deep cleaning, consult the
manufacturer, its service agent or a similarly qualified
person to avoid a hazard.
REF. 08785