Publicité
Les langues disponibles
Les langues disponibles
• Do not use the product in areas where
flammable gases or combustible
materials are used or stored.
• Do not exert excessive force or shock
on the product.
• Install the product where no obstacles
around the product block the
circulation of air.
Operation safety
• Never put the product in water.
• Do not disassemble, repair, or modify
the product.
• Unplug the product before you clean
it.
• If the air purifier produces a strange
noise, burning smell, or smoke,
immediately remove the power plug
from the electric outlet and call our
customer support.
• Do not spray any flammable materials
into the air inlet.
• Do not stick fingers or foreign objects
into the air inlet or outlet.
• Replace filters with new ones
according to filter replacement cycles.
Otherwise product performance may
deteriorate as a result.
• Do not push or lean against this
product, as it may topple over the
product. Otherwise physical injury or
product malfunction may occur as a
result.
Care Instructions
Unplug the product before cleaning.
To clean the product, wipe with a soft
moistened cloth. Use another soft, dry
cloth to wipe dry.
Vacuum clean the pre-filter regularly.
Note!
Never use abrasive cleaners or chemical
solvents as this can damage the
product.
Filter replacement
When replacing the filter it is essential
that the user proceeds as follows:
A LED on the top indicates a filter that
needs to be replaced.
Warning!
The power supply cord must be
disconnected during filter replacement!
1. Disconnect the power and wait until
the fan has stopped.
2. Remove the pre-filter by the pull-tag.
Clean the pre-filer with a vacuum
cleaner or with water depending on
the level of contamination.
3. Remove filter(s), and handle used
filters carefully, dispose the filter in
accordance with local environmental
regulations in your country.
4. Clean inside, removing all dust and
dirt.
5. Insert the new filter(s). (Do not touch
the carbon filter.)
6. Reconnect the power supply cord.
7. When you have replaced a filter,
press and hold the RESET button for 5
second. The reset initializes the filter
replacement cycle counter.
8. Attach the pre-filter.
5
Publicité
