Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
Procedures not specifically explained in this manual must be performed only by a
qualified technician.
WARNING!
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Release the
Trigger and unplug the tool from its electrical outlet before performing any inspection,
maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged
equipment. If abnormal noise or vibration occurs, have the problem corrected before
further use.
1. BEFORE EACH USE, inspect the general condition of the tool. Check for loose
hardware, misalignment or binding of moving parts, cracked or broken parts,
damaged electrical wiring, and any other condition that may affect its safe operation.
2. AFTER USE, wipe external surfaces of the tool with a clean cloth.
WARNING! If the supply cord of this power tool is damaged, it must be replaced only
by a qualified service technician.
BLADE MAINTENANCE
1. Unplug the tool.
2. Using the hex tool, remove the three head bolts (28).
3. The three blades (24, 25, and 27) and the two bushings (26) will be loose.
4. Clean, replace or sharpen the blades as required.
5. Replace blades as a set only. Reassemble by repositioning the blades, and bushings
as illustrated. Replace the head bolts and tighten them securely.
6. Test the product to be sure that it is working properly.
7. The left and right blades (24, 27) are slotted. They can be adjusted to change the
direction of the curl of waste material. To adjust:
a. Unplug the tool.
b. Loosen all three Head Bolts (28).
c. Make a slight adjustment to the Left or right blade (24, 27) as needed.
d. Tighten the Head Bolts (28).
e. Test the direction of the waste curl and repeat the steps above as needed.
Note: If the head bolts (28) are over tightened, then the center blade (25) will not
move freely enough, causing premature wear, or possibly preventing the tool from
operating. If the head bolts are not tight enough, the tool will not make a smooth cut in
the material.
16
CK104-MS
!
!
Right
Blade (24)
Center
Blade
(25)
Bushing
(26)
Left Blade (27)
Bolts (28)
!
Cutting
Head
(22)
Head
Fig.3
Publicité
Table des Matières
