Simons Voss Technologies WaveNet LockNode Guide Abrégé page 27

8. Hardware reset of external LockNodes
LED
flashes red/green
8. Hardware reset of external LockNodes
You can reset WaveNet Manager-enabled LockNodes (re-
cognisable by WNM in the article number):
1. Disconnect the LockNode from the power supply or re-
move the batteries.
2. Wait for about 20 seconds.
3. Press and hold the Init button.
4. Reconnect the power supply or replace the batteries.
LED lights up constantly red.
9
5. Release the Init button while the LED is constantly red.
9 All WaveNet information in the LockNode is deleted.
You can re-integrate the LockNode into your WaveNet (see
WaveNet manual).
The SmartIntego variant (SI.N.IO) can only be reset in the
SmartIntego Manager.
Meaning
Data is transferred.
27 / 104 | EN