Troubleshooting Guide - Zepter Therapy Air iOn PWC-570 Manuel D'utilisation

If problems occur when trying to operate the appliance, make sure that you have
followed the Instructions for Use correctly. Before you ring Zepter Service Centre for
help, please check the following:
PROBLEM
No air is coming out
Air flow speed does not
change
The particle sensor does
not alter
Operation speed
too low
The air outlet emits an
unpleasant odour
The particle sensor is
blinking
Other problems
If a problem persists after you have followed the procedures suggested in this table,
please call Zepter Service Centre.
30

10. TROUBLESHOOTING GUIDE

CHECK
• Is the appliance plugged into
the electricity supply?
• Are the panel lights off?
• Is the appliance supplied with
electricity?
• Is the automatic operational
mode selected?
• Is the room too dark?
• Is there any dust on the sensor?
• Does it constantly indicate
"unclean"?
• Does it constantly indicate
"very clean"?
• Have you cleaned or replaced a
filter?
• Have you cleaned or replaced
the filter?
• Ring Zepter Service Centre
• Turn the appliance off and ring
Zepter Service Centre.
SOLUTION
Plug the appliance into the power
socket 220-240 V.
Press the button to turn on the
appliance (POWER) and the
operational mode button (MODE).
Try to operate the appliance after
it is connected to the electricity
supply.
You cannot select a speed in
the automatic operational mode
(Normal).
You cannot select a speed in the
quiet night mode (Normal).
Clean the lens (follow the
instructions).
Reduce the sensor sensitivity (follow
the instructions).
Increase the sensor sensitivity
(follow the instructions).
Check if the filters have been
cleaned and replaced.
Check if the filters have been
cleaned and replaced.