Brandani techno 54667 Mode D'emploi page 11

INSTRUCTIONS FOR USE
Instructions for use
- Before first use it is advisable to boil some plain water twice and then rinse the
glass body
- Make sure the kettle is disconnected from outlet before pouring water inside
- Place on a flat dry surface. Open the lid and pour the required quantity of water into
the kettle paying attention to the maximum and
minimum levels indicated on the glass body. Close the lid.
- Adjust the length of the cord by wrapping it around the base and plug in. Press the "1"
button on the handle. The light will come on and the kettle will automatically start to
heat the water.
- Once the water in the kettle has reached boiling point the kettle will switch off. You can
turn on again by pressing the "I" button.
- Be careful of the steam that will come out of the lid to avoid risk of burns.
- If you wish to stop operation before the water has boiled press the "0" button on the
handle.
- After use unplug and pour the boiling water where required.
Protection against boiling dry
This function automatically turns the kettle off if switched on without containing
a sufficient quantity of water. The switch remains in the "1" position and the light
remains on. If this function starts, turn the kettle off and leave to cool. Disconnect
and replace on the base to reactivate the device.
54667m.indd 9
All manuals and user guides at all-guides.com
INSTRUCTION MANUAL | 9 | 9
08/07/16 13:50