Reset To Factory Default Settings - Axis M1145 Serie Guide D'installation

AXIS M1145 Series
3. Set the zoom level using the slider and click Perform auto
focus to focus the camera automatically.
Click in the Focus position bar to focus on a desired location.
4.
The buttons < and > move the focus position one step in either
direction. The buttons << and >> move the focus position in
multiple steps in either direction.
When satisfied, click Enable iris to enable the iris.
5.
The Pixel counter shows the number of pixels in an area of the image
and can be used to ensure that the size of the image fulfills certain
requirements, for example for face recognition. Use the mouse to move
and resize the pixel counter, or enter the number of pixels in the Width
and Height fields and click Apply.
Access the Product
Use the tools provided on the Installation and Management Software
CD to assign an IP address, set the password and access the video
stream. This information is also available from the support pages on
www.axis.com/techsup/

Reset to Factory Default Settings

Important
Reset to factory default should be used with caution. A reset to
factory default will reset all settings, including the IP address,
to the factory default values.
Note
The installation and management software tools are available on
the CD supplied with the product and from the support pages on
www.axis.com/techsup
To reset the product to the factory default settings:
1. Disconnect power from the product.
18