Whirlpool YWET4024HW Guide D'utilisation Et D'entretien page 12

Selecting Water Temperatures
NOTE: Always read and follow fabric care label instructions
to avoid damage to your garments.
Wash Temp
Hot
Some cold water is added
to save energy. This will be
cooler than your hot water
heater setting.
Warm
Some cold water will be
added, so this will be cooler
than what your previous
washer provided.
Cool
Some warm water may
be added to assist in soil
removal and to help dissolve
detergents.
Cold
A small amount of warm water
may be added to assist in soil
removal and to help dissolve
detergents. Water will be
colder than "Cool" setting.
Tap Cold
This is the temperature from
your faucet.
NOTE: In wash water temperatures colder than 60ºF (15.6ºC),
detergents do not dissolve well. Soils can be difficult to remove.
Some fabrics can retain wear wrinkles and have increased pilling
(the formation of small lint-like balls on the surface of garments).
8.
Select CYCLES
Press the CYCLES button to select your wash cycle.
See "Cycle Guide" for details on cycle features.
12
Suggested Fabrics
Whites and pastels
Durable garments
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed or fade
Light soils
Dark colors that bleed or fade
Light soils
Dark colors that bleed or fade
Light soils
9.
Press START/PAUSE to begin
wash cycle
Press the START/PAUSE button to start the wash cycle.
When the cycle has finished, the end-of-cycle signal will
sound (if set). Wait 1 minute for the lid to unlock. Promptly
remove items when cycle is done to avoid odor, reduce
wrinkling, and reduce rusting of metal hooks, zippers,
and snaps.
Unlocking the lid to add items
If you need to open the lid to add one or two missed items:
Press the START/PAUSE button to pause the washer; the lid
will unlock once the washer movement has stopped. This may
take several minutes if the load was spinning at a high speed.
Then close the lid and press the START/PAUSE button again
to restart the cycle.
To stop or restart your washer:
To stop the washer at any time, press the START/
n
PAUSE button and the cycle will pause.
To restart the washer, press the START/PAUSE button
n
and the cycle will resume.
NOTE: If the washer is paused while in the spin phase,
the lid will unlock after 1 minute. During that minute,
the Start/Pause button will be disabled.