Publicité
4
4.
The Vista Unit has numerous wiring options. Both inside and
outside channels can be used for wiring in any combination
required. Wiring in outside channels can be fed into furniture
and devices using supplied internal knockouts. Use the
provided knockout and grounding plate for electrical
terminations. To install, place into extrusion and rotate into
place. Tighten provided screws to secure plate. Use the
provided wire clips and moveable divider to separate the lower
compartment. The divider clips will snap into groove in the
extrusion. Holes in the wire clip may be used to secure wire ties.
5.
Wiring can be run in the internal compartment from overhead
5
using approved methods. Perforated metal or glass
decorative center panels are not intended to enclose
individual electrical conductors and/or splices.
6.
Install device plates as shown. Use provided device brackets
6
for wiring of electrical duplexes and lighting accessories. Use
supplied grommets on knockout openings to protect wire and
cables. Detailed instructions are provided with plates.
4
Snap-In Divider
and Wire Clip
(VSDIV/ VLDIV)
Small/ Large
Grounding Plate
with Knockout (VPG)
5
6
Publicité
