Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.
First remove the water tray on the outdoor unit as shown in Fig.6.1.
Fig. 6.1
For Multi-type models:
One-twin
2.
Do not remove the plastic seals trom the outdoor unit and the appropriate refrigerant pipes until
immediately before you con neet them, Fig.6.2
Fig. 6.2
3.
Align the refrigerant pipes correctly so that they line up with the valves and are not stressed. Place
the screw connector on the refrigerant line just on to the thread on the outdoor unit and
tighten the first few threads by hand, Fig.6.3.
NOTE: The refrigerant pipes must be connected to the valves on the outdoor unit with as
little stress as possible.
IMPORTANT: Before you continue, it is essential that you read the following instructions carefully.
4
86
One-three
Publicité
Chapitres
Table des Matières
Dépannage
