Bellman & Symfon BE1491 Mode D'emploi page 15

Trouble shooting
If Try this
A green light appears
• Check the baby monitor's and the receiver's batteries
on the baby monitor
and plugs.
but the receiver is not
• Move the receiver closer to the baby monitor.
activated
• Check that the baby monitor and the receiver are set
to the same radio key, see Changing the radio key in
the Installer's Guide.
The baby monitor is • Move the baby monitor closer to the baby or increase
not activated even the microphone's sensitivity, see Settings.
though the baby is
• Please note: Always make sure the baby monitor is
crying
out of the child's reach. Never place the baby moni-
tor in the child's crib or playpen.
26
If Try this
The baby monitor is • Reduce the sensitivity or move the baby monitor
activated too easily further away from the crib, see Settings.
The baby monitor is
• Increase the delay.
activated too fast For more information, read the section Settings.
The baby monitor is • Reduce the delay.
activated too slow For more information, read the section Settings.
The receiver is activated • There is probably another Visit system nearby
for no reason that triggers your system. Change the radio key
on all units, see Changing the radio key in the
Installer's Guide.
Two orange lights • Change the batteries. Only use 1.5 V AA (LR6)
appear every 10s lithium or alkaline batteries.
EN
27