Cleaning And Maintenance - Newteck Rhapsody dual 365 Mode D'emploi

The set temperature must be higher than the ambient temperature, in
order for the heating function to be activated.
* When the device is turned off or when the room temperature reaches
the set temperature, the heating function will stop and become a
cool breeze that will last approximately 40 seconds to help cool the
resistor. Then, the device will be in sleep mode.
If the room's ambient temperature is lower than the set temperature, the
heating function will be activated automatically. If the room temperature
is higher than the set temperature, the heating function will stop.
Note: The default temperature setting is 25°C.
In warm mode, when the ambient temperature is below 0 °C, the display
only shows 01, it does not show a negative temperature value.
The hot air mode runs for 9 hours, the machine will stop working
automatically after this time. Restart the device by pressing the power
button on the main body or by using the remote control.

- cLEANING AND MAINTENANcE -

Unplug the power cord before performing maintenance.
Do not place the fan on water or splash it, as this could
damage the machine.
Do not use banana oil, benzine, alcohol, bleach or metal
objects to clean the surface of the fan, as it may discolor
the surface.
Surface cleaning
Clean the surface with a soft dry cloth.
If it is especially dirty, you can dilute some soap or mild
detergent in water and moisten the cloth. Then wipe with
a soft dry cloth.
Air inlet/outlet
It is advisable that you clean the dust at least once a month
(depending on use). Dust accumulation is not healthy for
you and will reduce fan efficiency.
Use a soft brush or vacuum cleaner to clean the dust at
the air inlet and outlet.
49