Required Tools; Included Accessories - Danby DAC060EE1WDB Manuel Du Propriétaire

INSTALLATION INSTRUCTIONS
LOCATION
This air conditioner is designed to fi t inside a
standard double-hung window between the sizes of
23" and 36". The lower sash must allow for 14.5"
in vertical clearance.
This air conditioner is not designed for vertical,
slider type windows or "through the wall"
installation.
Ensure that the window and frame are structurally
sound and free from dry or rotted wood.
Install the air conditioner on a side of the building
which favors more shade than sunlight. If the
appliance must be in direct sunlight, it is advisable
to provide a shade awning to ensure effi cient
functioning.
Do not install the appliance where leakage of
combustible gas is suspected.
This air conditioner is designed to evaporate
condensation under normal conditions. Under
extremely hot or humid conditions, excess
condensation may overfl ow to the outside. The air
conditioner should be installed where condensation
cannot drip on pedestrians or neighboring
properties.
Provide suffi cient clearance around the appliance
to allow ample air circulation. The rear of the
appliance should be outdoors, it should not be in
a garage or another room. Keep the appliance
away from obstacles and at least 76 cm (30 inches)
above the ground. Ensure that curtains and other
obstructions do not block air fl ow to the appliance.
50.8 cm
(20 inches)
12 cm
(30.5 in)
50.8 cm
76.2 cm
(20 inches)
(30 inches)

REQUIRED TOOLS

• Screwdrivers: Phillips and fl at head.
• Power Drill: 3.2mm (1/8 inch) diameter drill bit
• Pencil
• Measuring Tape
• Scissors
• Carpenter's Level
Note: Save the shipping carton and packing
materials for future storage or transportation.
Remove the plastic bag from the carton containing
the installation hardware kit necessary for the
installation of your air conditioner. Please check
the contents of the hardware kit against the
corresponding model check list, prior to installation
of the appliance.

INCLUDED ACCESSORIES

1. Top rail
2. Filler panels
3. Sash lock
4. Lock frame x2
5. Remote control
6. Battery (AAA)
7. 3/8" screws x4
8. 1/2" screws x3
9. 3/4" screws x4
10. Window sash seal
11. Foam top window gasket
12. Foam insulation
1
2
3 3
4 4
7
12
11
10 0 0 0 0 10
9
8
5
6
7