Operation And Use; Dry Ironing; Steam Ironing - Beem DYNAMIC i-POWER Notice D'utilisation

DYNAMIC i-POWER

Operation and use

Dry ironing

Turn the steam flow regulator (3) to
‹
position 0.
During heating up, make sure that
‹
the appliance is placed upright on an
even surface.
Insert the plug of the appliance into
‹
the mains socket. The control indica-
tor (11) light up.
Set the desired temperature with the
‹
temperatur regulator (13).
The temperature indicators (9) light up
on both sides of the appliance during
heat-up.
Wait until the appliance has heated
‹
up, the control indicator (11) flashes
and the temperature indicators extin-
guish.
Fill with water
NOTE
► Only fill the the tank of the appliance
with tap water up to 17° dt. hard-
ness (3 mmol/l). If your tap water is
harder, use a mixture that consists of
equal parts of tap water and distilled
water.
► The lifecycle of the appliance is pro-
longed if pure distilled water is used.
Set the temperature regulator (13) to
‹
the "OFF" position and pull the plug
out of the mains socket.
Open the tank lid (2) (fig. C).
‹
Put the appliance with the ironing
‹
sole onto an even surface and incline
it back so that it stands on the rear
housing edge.
24
All manuals and user guides at all-guides.com
Use the measuring cup (17) to fill
‹
the tank (12) up to the "MAX" mark
(fig. D). The tank capacity is approxi-
mately 0.35 litres.
Close the lid of the tank (2).
‹
Move the iron horizontally back and
‹
forwards for approximately 30 sec-
onds; in this way, the water is cleaned
by the anti-calcification system of the
appliance.

Steam ironing

If necessary, fill the appliance with wa-
‹
ter (Filling with water section).
During heating up, make sure that
‹
the appliance is placed upright on an
even surface.
Insert the plug of the appliance into
‹
the mains socket. The control indica-
tor (11) light ups.
Set the temperature regulator (13)
‹
― according to the care label of the
fabric to be ironed ― between the me-
dium (●●) and maximum temperature.
Effective steam ironing is possible
within this range.
The temperature indicators (9) light up
on both sides of the appliance during
heat-up.
Wait until the appliance has heated
‹
up, the control indicator (11) flashes
and the temperature indicators extin-
guish.
Set the desired steam flow with the
‹
steam flow regulator (3).
BEEM - Elements of Lifestyle
EN