VONN Lighting SLICE Serie Guide D'installation page 3

Fig. 1
ROUND: CUT OUT
Ø5/8"(Ø15mm)
1. Cut (Ø5/8") hole in the ceiling
(Minimum ceiling thickness 1/4")
Fig. 3
Green / Ground
Black / Hot
White / Neutral
Power supply
3. Connect fixture wires to building wires
Connect each supply wire with appropriate dirver wire
connector
Installer tip: The fixture features electric low voltage
(ELV or 0-10V) dimming capabilities.
Fig. 5
5. Remove mounting bracket from fixture
www.vonn.com
Instructions
Dim-gray(0-10V)
Dim+purple(0-10V)
Cable to fixture
Fig. 2
2. Pull building supply wires through
ceilling cutout and open fixture box door.
Remove desired housing knockout and feed
building wires into housing using
appropriate connector.
Fig. 4
4. Place driver box into ceiling
Fig. 6
6. Attach mounting plate to ceiling surface
© VONN Lighting,2020