VONN Lighting SLICE Serie Guide D'installation

INSTALLATION GUIDE:
SLICE SERIES
VONN LIGHTING MODEL#
PARTS LIST
A
Please read and understand the entire manual
before attempting to assemble, operate, or install
the product.
All parts must be used as indicated in these
instructions. Do not substitute any parts, leave
parts out, or use any parts that are worn or broken.
Please handle the LED light with care when
unpacking. Do not apply pressure to the LED's, do
not open any factory sealed compartments, and do
not touch the LEDs with your hands.
VONN recommends to install the fixture on
its own independent circuit. Dd not install the
fixture on the same circuit with the other
appliances, or HVAC systems.
Place the wall switch in the "OFF" position of the
room you are installing the fixture.
www.vonn.com
VMCL000605E012
B D
LED INFO & WARNINGS
LED INFO & WARNINGS
GOGGLES
A. Mounting Bracket x 1
B.
Plastic Anchors x 3
C.
Anchor Screws x 3
D.
Wire Connectors x 5
Make sure that you have all necessary parts by
checking the parts list. If any part is missing or
damaged please contact VONN LIGHITNG
CUSTOMER SERVICE at 888-604-8666 for
a replacement.
Inspect the LED fixture prior to installation to make
sure that it has not been damaged during shipping.
VONN highly recommends to use a qualified,
licensed electrician to install the fixture.
Do not remove or replace VONN manufactured
parts that is provided with the fixture.
Shut "OFF" the electricity at main fuse box.
TOOLS YOU MAY NEED
PHILLIPS
TAPE MEASURE RUBBER
SCREW DRIVER
GLOVES
CIRCUIT BOX
OFF
© VONN Lighting,2020
DRILL
LADDER
ON
OFF