Setup / Operating The Function Keys - red lion IAMS 0001 Mode D'emploi

operAtIng tHe fUnCtIon keyS
Documentation for routing diagram.
In general:
When setting up the IAMS devices, you will be guided through all parameters
and you can choose the settings which fit the application. For each menu
there is a scrolling help text which is automatically shown in line 3 on the
display.
Setup is carried out by use of the 3 function keys:
will increase the numerical value or choose the next parameter
1
will decrease the numerical value or choose the previous parameter
2
will save the chosen value and proceed to the next menu
3
When setup is completed, the display will return to the default state 1.0.
Pressing and holding
state (1.0) without saving the changed values or parameters.
If no key is activated for 1 minute, the display will return to the default state
(1.0) without saving the changed values or parameters.
further explanations:
fast setpoint adjustment and relay test: These menus allow you to make a
quick setpoint change and relay test when the FastSet menu is activated.
This function can only be activated when the relays are set for setpoint
function and are controlled by a setpoint.
Pressing and
1
state of the relay.
Pressing will save the setpoint change.
3
Holding down
3
without saving the setpoint change.
will return to the previous menu or return to the default
3
simultaneously will activate a relay test and change the
2
for more than 1 second will return the unit to the default state
SetUp /
17