Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
Step 7
Attach 3 pcs reflector spacers (FF) and 3 pcs washers (GG)
to burner assembly (C) firstly.
Slide 3pcs washers (GG) over threaded end of spacer.
Attach the reflector assembly to the top of reflector spacer
(FF) using 3 pcs washers (GG) and 3 pcs wing nuts (KK).
Hardware Used
Reflector
FF
spacer
GG
Washer
KK
Wing nut
Step 8
Connect the gas hose and regulator using clip and tighten
with screwdriver.
Attach the regulator to the gas cylinder and tighten with
spanner.
WARNING! Ensure the hose does not contact any high
temperature surfaces, or it may melt and leak causing
a fire.
Tighten the reflector spacers.
x 3
x 9
x 3
Page 11
2022-2023
Publicité
