Residual Heat Indication; Booster Function; Timer - VonReiter EKI8050/6FLEX Instructions D'utilisation Et D'installation

Residual heat indication

After the switching off of a heating zone or the complete stop of the hob, the heating zones are
still hot. This is indicated by displaying [ H ] symbol.
The symbol [ H ] disappears when the heating zones may be touched safely.
As long as the residual heat indicators are on, don't touch the heating zones and don't put any
heat sensitive object on them. There are risks of burn and fire.

Booster function

The Booster function [ P ] and the Double Booster [
heating zone.
If this function is activated the heating zones work for 10 minutes with an ultra high power.
Booster is needed for example to heat up rapidly big quantities of water, like rice, pasta or
noodles.

Start up / Stop the booster function:
Action
Start up the Booster
Stop the Booster

Start up / Stop the double booster function:
Action
Start up the Booster
Start up the Double Booster
Stop the Double Booster

Power management:
When it comes to the power, the cooking zones are running by pairs and cannot exceed an
overall maximum of power. If the selected heating levels for both zones exceed the maximum
available amount of power, the powermanagement function is automatically reducing the power
from one of these zones. The display of this zone is first blinling ; the level is then automatically
reduced to the highest suitable position.
Heating zone selected
[ P ] is displayed

Timer

The timer is able to be used simultaneous with all heating zones and this with different time
settings (from 1 to 999 minutes) for each heating zone.

Setting and modification of the cooking time :
Action
Select the power level
Select theTimer
Decrease the time
Increase the time
After a few seconds, the [ min ] display stops with blinking.
The time is confirmed and the timer starts.
Control panel
Slide to the end of the "SLIDER"
Or press directly on the end of
the "SLIDER"
Slide on the "SLIDER"
Control panel
Slide to the end of the "SLIDER"
Or press directly on the end of
the "SLIDER"
Press 2 times the end of the "SLIDER" [
Slide on the "SLIDER"
The other heating zone: (example: power level 9)
[ 9 ] goes to [ 8 ] and blinks
Control panel
slide on the "SLIDER"
Press simultaneously key [ - ] and [ + ] Timer display on
from the timer until the
desired display is on
Press key [ - ] from the timer
Press key [ + ] from the timer
27
] add a boost of power to the selected
Display
[ P ]
[ 9 ] to [ 0 ]
Display
[ P ]
[ 0 ] to [ P ]
Display
[ 1 ] to [ P ]
[ 60 ] to 59, 58...
Time increase
and P ]