Safety Instructions; Technical Data - Anslut 006867 Mode D'emploi

SAFETY INSTRUCTIONS

• Do not connect power strips to each other.
• Do not cover the power strip.
ELECTRICAL SAFETY
New installations and extensions to existing
systems should always be carried out by
an authorised electrician. If you have the
necessary experience and knowledge
(otherwise contact an electrician), you can
replace power switches and wall sockets,
fit plugs, extension cords and light sockets.
Incorrect installation can result in fatal injury
and the risk of fire.
SYMBOLS
Read the instructions.
Approved in accordance with the
relevant directives.
Recycle discarded product as electrical
waste.

TECHNICAL DATA

Rated voltage
Size
Protection rating
Current
230 V ~ 50 Hz
169 x 53 x 81 mm
IP21
16 A
ASSEMBLY
INSTALLATION
1. Disconnect the power supply by taking
out the fuse and check that the wires are
without voltage.
2. Strip about 11 mm off the ends of the
wires.
3. Dismantle the product into three parts.
Do not remove the screws in the middle
during the installation.
FIG. 1
4. Open the grommets and push the cable
into the box.
5. Press the box into the corner so that the
sides rest against the walls and screw on
with screws in the four screw holes (A).
FIG. 2
6. Connect the wires to the power point
and USB connection according to colour
and the markings N and L
sectional area of the wires is 2.5 mm².
– L, brown (live)
– , green and yellow (earth )
– N, blue (neutral)
FIG. 3
7. Check that all the connections are correct.
8. Screw the front onto the box. Make sure
not to pinch the wires. Press the frame in
place.
EN
. The cross-
7