Care And Cleaning - Nesco CU-25 Guide D'entretien Et D'utilisation

1. Always use the coffee urn on a flat level surface.
2. Remove lid, filter basket and pump tube. Fill with COLD WATER to desired
amount on water gauge. Do not fill more than the MAX mark or operate when
the level is below the MIN mark. Capacity = 3 to 25 cups.
3. Insert pump tube firmly into the heating element at bottom of the urn body
then place filter basket on tube.
4. Add coffee grounds evenly into filter basket. (1 Tbsp = 1 cup or to taste).
NOTE: To heat only water, use basket and tube but do not add coffee grounds.
5. Place lid on urn body and turn clockwise to lock into place.
6. Check power switch is OFF position. Plug cord into grounded 120V. electric
outlet. Press power switch ON, the red HEATING light will turn on to indicate
start of brew cycle.
7. When finished brewing. about 20 to 45 minutes or until you can no longer
hear noise from the pump, remove coffee basket and grounds.
• This also helps maintain coffee flavor.
• The urn's lid can be used as a carrying tray when disposing of wet coffee
grounds.
8. WARNING - NEVER OPERATE WHILE EMPTY. This can damage the heating
element and void warranty.
9. To serve coffee, place cup under faucet then lift or press faucet handle to
serve.
10. When about 3 cups of coffee is remaining in the tank (MIN water mark), turn
the appliance off and unplug it from the electric outlet.
"BOIL DRY" SAFETY FEATURE:
Boil dry is the result of boiling all the water out of the urn. To prevent boil dry
accidents, this appliance is equipped with a thermal protector with an automatic
reset. If the water in the tank is completely boiled away, the appliance will
automatically turn off. Empty and let the urn cool down about half an hour and
then try another brew cycle. Operators are advised to turn the appliance off
when not in use, especially overnight.
1. Before cleaning, turn off any switches and ensure the power cord is removed
from the electrical outlet and allow appliance to cool.
2. Empty remaining liquid by removing lid, basket and pump tube and slowly
pour liquid into drain.
3. Wipe the outside area with a damp cloth and dry with a lint free cloth.
4. Never place appliance in water or other liquids
5. Never use abrasive cleaners or scouring pads.
6. Allow to dry before storage.
7. Some water has higher mineral content that can discolor the inside of the urn
body. To remove these stains, fill to desired level with COLD WATER and use
several tablespoons of vinegar or cream of tartar powder. Allow to heat for
one BREW cycle, then turn power OFF and remove plug from wall outlet. Drain
solution, rinse and clean as noted above.
Operation
Care and Cleaning Instructions
3