Care And Cleaning - Nesco CU-30 Guide D'entretien Et D'utilisation

1.
Read and follow all instructions and save for reference.
2.
Remove all packaging and labels.
3.
Clean all parts, except Base, following instructions in the 'Care and Cleaning ' section.
4.
Wipe the Base with a damp cloth.
5.
TO REDUCE RISK OF SHOCK HAZARD NEVER IMMERSE THE BASE IN WATER OR ANY
OTHER LIQUID.
1.
Remove lid and filter basket. Fill with COLD WATER to desired amount on water gauge.
Do not fill more than the MAXIMUM fill mark on water gauge or operate when the level
is below the bottom of the water gauge sight tube.
2.
Place filter basket on tube and insert pump tube firmly into the heating element inside
the urn body, at the center. This will assure proper pump action.
3.
Add coffee grounds evenly into filter basket. No paper filter required. (1 Tbsp = 1 cup or to
taste). NOTE: To heat only water, do not add coffee grounds to basket.
4.
Place lid in position and turn clockwise to lock into place.
5.
Check power switch is OFF position. Plug cord into grounded 120V. electric outlet.
Press power switch ON, the red HEATING light will turn on to indicate start of brew
cycle.
6.
When finished brewing the green KEEP WARM light will turn on indicating contents
are ready to serve and will keep contents warm until unit is turned OFF. During the
warm cycle you may hear noises similar to brewing, this is normal and the unit is not
brewing but only keeping contents warm.
7.
NEVER OPERATE APPLIANCE EMPTY. This can damage the heating element and void
warranty.
RESETTING APPLIANCE OVERHEAT PROTECTION
This appliance has an overheat protection device that will automatically stop heating if
operated without enough water or ambient temperatures are too high.
•
To reset - Remove cord from electrical outlet and allow appliance to cool. Located on the
side of the unit is a button that must be pressed once to reset device.
•
Check that the switch is in OFF position and insert cord into grounded 120V outlet.
•
Your unit is ready to use. If this does not work, contact The Metal Ware Corporation
Customer Service Center (800) 288-4545 or nesco.com for repair.
CARE AND CLEANING INSTRUCTIONS
1.
Before cleaning turn off any switches and ensure the power cord is removed from the
electrical outlet and allow appliance to cool.
2.
Empty remaining liquid by removing lid, basket and pump tube and pouring liquid into
drain.
3.
Wipe the outside area with a damp cloth and dry with a lint free cloth.
4.
Never place appliance in water or other liquids
5.
Never use abrasive cleaners or scouring pads. DO NOT use Baking Soda because it
can pit the metal and discolor permanently.
6.
Allow to dry before storage.
7.
Some water has higher mineral content that can discolor the inside of the urn body. To
remove these stains fill to desired level with COLD WATER use several tablespoons of
vinegar or Cream of Tartar powder. Allow to heat for one BREW cycle, then turn power OFF
and remove plug from wall outlet. Drain solution, rinse and clean as noted above.
BEFORE FIRST TIME USE
OPERATION
3