English - Corsair HYDRO Serie Mode D'emploi

IMPORTANT NOTICE
Quick Start Guide is a general installation guide and does not cover the specifics of individual case or
radiator mounting.
CORSAIR recommends you thoroughly leak-test your custom cooling system for at least 24 hours to ensure
that the system is securely sealed and operating reliably. CORSAIR warranty does not cover any hardware
damage resulting from poorly executed, improper and otherwise hasty assembly of your custom water-
cooling system.
Disassembly of CORSAIR HYDRO X products is highly discouraged due to complex design of components.
Such action may result in irreparable mechanical, electrical or chemical damage that may void the warranty.
For an exact and up-to-date product compatibility list, please refer to CORSAIR website.
PACKAGE CONTENTS
A
A — x1 XM228 WATER BLOCK WITH PREINSTALLED THERMAL MATERIAL
B — x1 XM228 MOUNTING CLIP WITH PREINSTALLED THERMAL MATERIAL
PREREQUISITES (NOT INCLUDED)
C — x1 PHILLIPS-HEAD SCREWDRIVER
B
C
1
INSTALLATION
Precaution: Take care to discharge any electrostatic charges.
1. Remove protective film from thermal pad (Figure 1). Place your M.2 NVMe (with bottom side facing down)
onto XM2 2280 Mounting clip (B)(Figure2) around 6mm from the edge (Figure 3).
Figure 1
Figure 3
2. Remove protective film from thermal pad (Figure 1). Place and press down XM2 2280 Water block (A)
onto your M.2 NVMe with XM2 2280 Mounting clip (B) until the clip closes (Figure 2).
Figure 1
Figure 2
B
Figure 2
A
B
2

ENGLISH