Product Information; Intended Use; Scope Of Delivery - Bosch Stora BP 200 EK Notice D'installation Et D'entretien Pour Le Professionnel

Product information

H Risk of scalding
▶ When the cylinder is in operation, temperatures in
excess of 60 °C can occur. Therefore, allow the
cylinder to cool down prior to carrying out any work
on the solar or heating circuit.
▶ Activate the automatic air vent valve only after the
temperature of the heat transfer fluid and the
heating water has dropped below 60 °C.
H Notices for the target group
These installation instructions are intended for gas,
plumbing, heating and electrical contractors.
All instructions must be observed. Failure to comply
with instructions may result in material damage and
personal injury, including danger to life.
▶ Read the installation, service and commissioning
instructions (heat source, heating controller,
pumps, etc.) before installation.
▶ Observe the safety instructions and warnings.
▶ Follow national and regional regulations,
technical regulations and guidelines.
▶ Record all work carried out.
H Handover to the user
When handing over, instruct the user how to operate
the heating system and inform the user about its
operating conditions.
▶ Explain how to operate the heating system and draw
the user's attention to any safety relevant action.
▶ In particular, point out the following:
– Alterations and repairs must only be carried out
by an approved contractor.
– Safe and environmentally compatible operation
requires inspection at least once a year and
responsive cleaning and maintenance.
▶ Point out the possible consequences (personal
injury, including danger to life or material damage)
of non-existent or improper inspection, cleaning
and maintenance.
▶ Point out the dangers of carbon monoxide (CO) and
recommend the use of CO detectors.
▶ Leave the installation instructions and the operating
instructions with the user for safekeeping.
18
2 Product information
These installation and maintenance instructions apply to the following
buffer cylinders (cylinders):
• BP 200 EK 3x 1 ½" female connections for immersion elements
• BP 500 EP 3x 1 ½" female connections for immersion elements and
handhole
• BP 1000 E 3x 1 ½" female connections for immersion elements
2.1

Intended use

The cylinder must only be used to heat heating water and operated in
sealed heating systems.
All other use is considered unsuitable. Any damage resulting from
prohibited operations is excluded from liability.
2.2

Scope of delivery

200-litre cylinder
• Storage cylinder in PU rigid foam
• Casing lid
• Technical documents
• Pack of adjustable feet
• Foil jacket
500-litre cylinder
• Storage cylinder in PU rigid foam
• Flange cover
• Casing lid
• Pack of adjustable feet
• Technical documents
• Foil jacket
1000-litre cylinder
• Storage cylinder
• Floor insulation
• Casing lid
• Upper insulation
• Technical documents
• Fibre insulation with PVC outer layer
Stora – 6721835329 (2021/04)