Use; Measuring Weight - Beurer GS 39 Mode D'emploi

6. Use

6.1 Batteries
If present, pull the battery insulating strip off the battery compartment cover or remove the battery's
protective film and insert the battery according to the polarity. If the scale fails to operate, remove
the battery completely and insert it again. Your scale is equipped with a "replace battery" indicator.
When the scale is operated with a battery which is too weak, "Lo" appears in the display field and
the scale automatically switches off.
Display DE
Lo Batterie
schwach
The battery must be replaced in this case (3 x AAA 1,5V).
Place the scale on a firm, flat surface; a firm floor covering is a basic requirement for
correct weight measurement.
When supplied to the customer, the scales are set to weigh in "kg". To the rear of the scales, there
is a button „kg/lb/st" which you can use to change to 'pounds' and 'stones' when the scale is in
English.

6.2 Measuring weight

Place the scale on a firm level floor (no carpet); a firm floor covering is required for correct
measurement.
Step onto the scale. Stand still with your weight distributed equally on both feet.
The entire display (Fig. 1) appears up to "0.0"
(Fig. 2) as a self-test (tap-on technology).
Display DE
8888 Beep
Now the scale is ready to measure your weight.
Display DE
0.0 Das Gerät
ist betriebs-
bereit
Now step onto the scale. Stand still on the scale with your weight distribut-
ed evenly between both legs. The scale immediately begins to measure your
weight. After flashing twice the final measurement result appears on the dis-
play. (Fig. 3)
There is also an acoustic output. The scale switches off 10 seconds after
you step down from it. The measuring result remains visible during this time.
EN FR
Battery weak Batterie faible
EN FR
Beep Beep
EN FR
The device L'appareil est
is ready for prêt à fonc-
use tionner
15
ES
Pila débil
Fig. 1 Fig. 2
ES
Beep
ES
El aparato está
preparado para
el servicio.
Fig. 3
RU
Слабый заряд
батарейки
RU
Звуковой
сигнал
RU
Прибор готов
к работе