Back Panel - resident dj 10028788 Mode D'emploi

14. Master Level Display
The LED display shows the level of the left and right master output
15. Crossfader
Mix the signal of one channel with another. If the Crossfader is at the center position, the
sound from both channels can be heard.
16. Mic 1 Socket
Connect your microphone with 1/4" or XLR jack plug here.
17. Mic 2 Socket
Connect your microphone with 1/4" jack plug here.
18. Headphone Socket
Connect your headphone with impedance between 8 and 600 Ohms to this connector.

Back panel

19 20
19. Power Switch
Turns the mixer on or off when the power supply is connected.
20. AC Connection
This unit applies 220V-240V AC power source.
21. Master Output
Master output connects to the main amplifier (DJ final mix after crossfader section), and
accepts RCA jacks.
22. BOOTH OUTPUT JACKS
Connect the mixer to a second receiver or amplifier powering speakers in the DJ booth
or in a remote location
23. RECORD OUTPUT JACKS
Connect the mixer to a second receiver or amplifier powering speakers in the DJ booth
or in a remote location.
23
21 22
24 24
13