Insignia NS-HWMG1754G Mode D'emploi page 7

Step 2 Securing the hinged sides and the left side panel
:
1 Secure the lower hinged braces in the straight position with two of the 10 mm body screws (M6).
2 Align the 7 mm screws (M5) on the lower edge of the left side (M2) with the holes in the cross braces on the stand
body (M1) (as shown in the detail below), then attach the left side. Secure the left side (M2) to the stand (M1) body
using two of the 28 mm side support screws (M12) provided.
3 Add rubber glass supports (M7 and M8) to the top shelf brackets and the bottom, respectively.
M2
You'll need:
M7
M12
M12
M7
M6
M8
M6 (2)
M12 (2)
www.insigniaproducts.com
NS-HWMG1754G / NS-HWMG1754M / NS-HWMG1754M-C
M7
M8
M7
M6
M8 (4)
M7 (8)
7