Charge The Battery Pack; Using The Ac Adaptor - Panasonic PV-DAC14 Manuel D'utilisation

Index of Controls/Supplying Power
AC Adaptor
DC Output Connector
CAUTION:
This unit will operate on 110-240V AC. An
AC plug adaptor may be required for voltages
other than 120V AC. Please contact either a
local or foreign electrical parts distributor for
assistance in selecting an alternate AC plug.
We recommend using the accessory power
plug adaptor (VJSS0070 or KZDB4ZE00001)
in an area which has special AC outlets.

Charge the Battery Pack

1
Connect and plug in the cables as shown
above.
• Remove the DC Cable, if attached, from the
adaptor.
2
Attach the Battery to the AC Adaptor and
charge it.
APPROXIMATE CHARGE TIME FOR DIFFERENT
BATTERIES IS AS FOLLOWS:
CGR-DU06 (7.2 V/640 mAh)
CGA-DU12 (7.2 V/1 150 mAh)
CGA-DU21 (7.2 V/2 040 mAh)
4
All manuals and user guides at all-guides.com
CHARGE Lamp
AC Power Cable
1 h 40 min.
2 h 25 min.
3 h 55 min.
• Since the Battery will not be charged when
the DC Cable is connected to the AC Adaptor,
disconnect it from the AC Adaptor.
• The [CHARGE] Lamp lights up, and charging
starts.
• When the [CHARGE] Lamp goes off, charging is
completed.
• When the battery is completely discharged, the
[CHARGE] Lamp blinks at first, but the battery is
charged normally. When the temperature of the
battery is too high or low, the [CHARGE] Lamp
blinks and the charging time becomes longer
than usual.
3
Remove the Battery by sliding it out and
then lift up.
About the Flashing of the CHARGE
Lamp
• Charge the Battery within an ambient temperature
range of 10 °C and 30 °C.
• If charging is done in extreme low or high
temperatures, Battery charge time increases.
CHARGE Lamp flashes when...
• The Battery is being charged, but charging is
taking longer than normal.
• Charging is not possible. Remove the Battery
once, wait a short time, then re-attach it for
charging.

Using the AC Adaptor

For Model PV-GS19/31/34/35
DC Cable
(K2GJ2DC00011)
(Supplied)
1
Connect the DC Cable to the Camcorder.
2
Connect the DC Cable to the AC Adaptor.
3
Connect the AC Cable to the AC Adaptor
and the AC Jack.
• When the DC Power Cable (supplied) is connected
to the AC Adaptor, the AC Adaptor cannot charge
the Battery.
(PV-GS35 shown)