1byone Audio-Technica AT3600 Manuel D'instructions page 10

Installing a new replacement stylus
EN
1. Grasp both sides of the stylus holder and insert the stylus grip into the cartridge rear
DE
tab of the cartridge.
FR
Stylus holder ②
ES
IT
Stylus grip ①
2. Push up the stylus holder until it clicks and locks completely in place.
Do not leave any space
Troubleshooting
These turntables are manufactured to the highest standards and undergo strict quality
controls before leaving the factory. Faults that may possibly occur are not necessarily
due to material or production faults but can sometimes be caused by incorrect use or
unfortunate circumstances. Therefore the following list of common fault symptoms is
included.
There is no power:
- The turntable is not connected to the power supply.
- No power at the outlet.
Power is on, but the platter doesn't turn:
- Drive belt is not installed or has slipped off.
- Turntable is not switched to turntable mode. Press the MODE button to turn on
turntable mode; the indicator light will turn red.
- The unit automatically switched in standby mode, press the Mode button to resume
operation.
Turntable is spinning, but there is no sound, or sound is not loud enough:
- Tone arm is lifted up by the left lever.
- Ensure the PHONO/LINE switch is set correctly. If using the internal Preamp the
switch should be set to LINE.
- The speaker needs to be connected to the turntable.
- Stylus protector is still on.
All manuals and user guides at all-guides.com
Engage the rear tab rst
16
No signal through one or other channel or both channels:
- Phone input not selected at amplifier.
- Amplifier not switched on.
- Amplifier or speakers muted.
- No connection to the speakers.
- No connection between turntable and amplifier.
- Wire leads not connected the cartridge.
Strong hum on phono input:
- No ground connection from cartridge, arm, or arm cable to amplifier or ground loop.
- Turntable too close to speakers.
Distorted of inconsistent sound from one or both channels:
- Turntable is connected to wrong input of amplifier.
- Needle or cantilever damaged.
- Drive belt overstretched or dirty.
- Platter bearing without oil, dirty or damaged.
- Dust on stylus.
- MM/MC switch on pre-amplifier set incorrectly.
Remark: Due to the ErP Stage 2 requirements for power saving measures, a
unit which is connected to the mains power will switch itself to standby mode
automatically if no music has been playing for about 15 minutes.
If your unit switches off regularly, this is no defect.
Specifications
Turntable
Power AC power adapter, DC output 15V 2400mA
Power Consumption 70W
Turntable Speed 33 1/3, 45 RPM
Wow and Flutter
±0.15%
Signal to Noise -65dB
Tracking Force Range 0-6.0g
Effective Tonearm Length 8.6" (218.5mm)
16.34" x 14.17" x 5.51" (415 x 560 x 240mm) (lid
Dimensions (L x W x H) closed), 16.34" x 16.34" x 16.34" (415 x 415 x 415mm)
(lid open)
Weight 20.9lb (9.5kg)
17
EN
DE
FR
ES
IT