Kronos pH/ORP Manuel D'installation page 9

Paragraph 7 – Statistics
Programming
PROG
Config.
Stats
T.Pompa
T.Pump
0h12m
T.Tube
0h5m
Q.Pump
0,79l
Power
12
Alm.Meas
1
Reset
Stats
T.Pompa
Paragraph 8 – Password
Programming
PROG
Config.
Password
****
Password
0000
0000138014
Reset?
Yes
rev. 1.0 EN
From the main menu, by pressing the
access the statistics:
- T.Pump = operating time of the pump.
- T.Tube = operating time since the last tube replacement.
- Q.Pump = quantity dosed by the pump in liters; this data is
calculated based on the memorized calibration value.
- Activations = number of pump activations.
- Alm.Meas = number of alarms relating to measure.
- Reset = use the
otherwise (NO), then confirm by pressing
Press the key to return to the main menu.
By setting the password, the programming section can be
accessed to view all the setup parameters, but every time
you try to change the settings you will be prompted for the
password.
The flashing line indicates the editable number; press
to select the number (from 1 to 9), then press
the number to modify, and then press
By setting "0000" (default), the password will be eliminated.
Operation
key to reset the counters (YES) or
Operation
to confirm.
key you can
.
to select
7