Freeman P800AJS Mode D'emploi page 6

MODEL: P800AJS
on the engine.
NO LIGHTS ON AND NO BUZZING:
The battery may be to low. Make sure the clamps
are connected correctly, press the "BOOST" button
and wait for the GREEN LIGHT to come on. If the
light does come on, turn on the engine within 30s.
If the light does not come on, take the vehicle to a
certified mechanic or consult the owner's manual.
Boost Button
Correct Light
Reverse Light
4. Start the car engine. If after 3 seconds engine does
not start, turn key to "OFF" position. Detach the car
jumper clamps, then restart steps 1-4.
10
HTTP://WWW.FREEMANTOOLS.COM
5.
Remove the clamps from the battery terminals.
6. Unplug the cable plug from the jump starter.
1-888-669-5672
MODEL: P800AJS
CHARGING THE CAR JUMPER
1.
Plug wall charger/car charger cable into the wall/
car input. Then plug the cable into the input port of
the car jumper. The light indicator should start to
blink while the jumper is being charged.
CHARGING A PHONE, TABLET, OR
OTHER USB DEVICES
1. Plug the USB cable into the USB output on the
jump starter. Then insert charging cable into the
device that needs to be charged. Press the power
button on your jump starter and the device will
begin to charge.
HTTP://WWW.FREEMANTOOLS.COM
CHARGING OTHER DEVICE
1. The car jumper also has 15V/10A output. Check
the device's voltage and current output rating
before using.
1-888-669-5672
11