Radio Setup - Samsung HT-J5150 Manuel D'utilisation

Settings
Reset
Reverts all settings to their defaults. Requires that
you enter your security PIN. The default security
PIN is 0000.

Radio Setup

~ To listen to the radio, you must connect the
supplied FM antenna.
Operating the Radio with the Remote Control
1. FUNCTION
Press the
2.
Tune to the desired station.
~ Preset Tuning 1 : Press the 5 button to
select PRESET, and then press the
UP, DOWN
button to select a preset station.
- Before you can tune to preset stations, you
must add preset stations to the product's
memory.
~ Manual Tuning : Press the 5 button to
select MANUAL, and then press the
UP, DOWN
button to tune in to a lower or
higher frequency.
~ Automatic Tuning : Press the 5 button to
select MANUAL, and then press and hold
TUNING UP, DOWN
the
seconds to automatically search the band.
Selecting Mono or Stereo
MO/ST
Press the button.
~ Each time you press the button, the sound
switches between STEREO and MONO.
~ In a poor reception area, select MONO for a clear,
interference-free broadcast.
Presetting Stations
Example : Presetting FM 89.10 into memory.
1. FUNCTION
Press the
2. TUNING UP,
Press the
the FM frequencies, and then select <89.10>.
3. TUNER MEMORY
Press the
C
button at the bottom of the remote).
button to select FM.
TUNING
TUNING
button for a few
button to select FM.
DOWN
button to scroll
button (the yellow
16
- English
4. TUNER MEMORY
Press the
within about 5 seconds. The station is stored in
memory.
TUNER MEMORY
If you press the
✎
repeatedly without changing the station, the
inputted station may be overwritten.
5.
To preset another station, repeat steps 2 to 4.
~ To tune in to a preset station, press the
TUNING UP, DOWN
To delete all Preset FM stations at once, press the
✎
TITLE MENU
button for about 5 seconds in FM
Manual mode until DEFAULT PRESET appears
on the display.
Recording FM Radio
You can record your favourite radio broadcast on a
USB storage device.
1.
Insert a USB device into the USB jack on the
front of the product.
2. FUNCTION
Press the
TUNING
then press the
select the station you want to record.
3. RED (A)
Press the button to start recording. The
recording process begins.
~ The recorded time is displayed on the left and
the recording time still available, based on
the amount of free space in the USB storage
device, is displayed on the right.
4. EXIT
Press the button to finish your recording.
The recording is stopped and saved as an .mp3
file at the same time. To play the recorded file,
refer to "Playing Files on a USB Device".
The recorded file is saved in the Tuner folder which
✎
is created automatically.
Only the (OPEN/CLOSE),
✎
MUTE, and VOLUME +/-, buttons are operable
while FM radio is being recorded.
If you don't press any buttons while recording, the
✎
screen saver will be enabled.
Sound effects, such as DSP, EQ, etc., are not
✎
recorded during FM radio recording.
The radio is recorded at a set, default volume
✎
even if you change the volume or press the
button during the recording process.
button again
button
button.
button to select FM, and
UP, DOWN
button to
MIC 1
5V 0.5A
MIC 1 MIC 2
(POWER), EXIT,
MUTE
5V 0.5A
MIC 2