Troubleshooting; Technical Specifications - Sencor SVC 7CA-NAA1-09 Instructions

SVC 7CA-NAA1-09 / SVC 7CA-NAA1-10 /SVC 7CA-NAA1-11 / SVC 7XX-NAA1-YY

TROUBLESHOOTING:

Before you decide to contact an authorized service center, please read these following tips in the
troubleshooting chart:
Problem
The motor will not start
Low suction output
The power cord is not wound
in completely
The power cord cannot be
pulled out
The speed control is not
working
The power cord starts to wind
in when you not required to
do so.

TECHNICAL SPECIFICATIONS

Rated voltage .......................................................................................................................................120V AC
Rated frequency .........................................................................................................................................60 Hz
Suction power ................ 200W (SVC 7CA-NAA1-09), 240W (SVC 7CA-NAA1-10), 280W (SVC 7CA-NAA1-11)
Rated current .........9 amps (SVC 7CA-NAA1-09), 10 amps (SVC 7CA-NAA1-10), 11 amps (SVC 7CA-NAA1-11)
Power cord length ..........................................................................................................................6 m/236.2 in
Operational range ........................................................................................................................8.5 m/334.6 in
Dust bag capacity ........................................................................................................................................ 2.5 l
Dimensions (length x width x height) ......................................... 390 x 315 x 245 mm/22.43 x 12.29 x 13.65 in
Weight ...................................................................................................................................... 10.6 kg/18.3 lb
Amendments to text and technical parameters are reserved.
Copyright © 2014, Fast ČR, a.s.
Vacuum cleaner
Possible cause
- The power cord is not fi rmly
inserted in the socket
- The wall power outlet is
damaged
- The vacuum cleaner is not
switched on
- The product is clogged
- The dust fi lter needs cleaning
- The fi lter is clogged
The power cord may have slipped
off of the winding pulley during
winding.
The power cord is wound up
incorrectly
The product is broken down
The winding mechanism has
malfunctioned
EN-9
Recommended action
- Insert the plug fi rmly into the
power outlet
- Inspect the power outlet
- Switch the product on
- Remove the blockage or foreign
object
- Clean the dust fi lter
- Clean the fi lter
Hold the power cord during the
winding. Apply slight tension
(by pulling the power cord back)
to the power cord during the
winding process
Press the winding button and try
to rewind the power cord
Have the product repaired by
a technician.
(only by a qualifi ed technician)
Have the product repaired by
a technician.
(only by a qualifi ed technician)
Revision 10/2014