Sencor SVC 7CA-NAA1-09 Instructions page 8

SVC 7CA-NAA1-09 / SVC 7CA-NAA1-10 /SVC 7CA-NAA1-11 / SVC 7XX-NAA1-YY
1) Open the vacuum cleaner fi lter area by pressing the clip while simultaneously pulling it upwards.
2) Remove it from the plastic holder and insert a new bag by pulling on the collar of the dust bag in the
direction of the arrow.
3) Close the lid of the vacuum cleaner until you hear a click.
Changing and cleaning the outfl ow H.E.P.A. fi lter and the infl ow micro-fi lter
F
1
2
1 Lid clip
2 Outfl ow H.E.P.A. fi lter
3 Grill of the infl ow micro-fi lter
1) Open the vacuum cleaner fi lter area by pressing the clip while simultaneously pulling it upwards.
2) Remove it from the plastic holder by pulling on the collar of the dust bag in the direction of the arrow in order
to make room for fi lter removal.
3) Pull the infl ow micro-fi lter grill towards yourself and take it out.
4) Pull to remove the outfl ow H.E.P.A. fi lter and take it out.
5) If the fi lters are not very dirty, you can wash both of them under lukewarm running water. If they are very
dirty, replace them with new ones.
6) Place the outfl ow H.E.P.A. fi lter and the infl ow micro-fi lter back into their respective positions.
7) Return the dust bag.
8) Close the lid of the vacuum cleaner until you hear a click.
Note:
Never insert the fi lters back into the vacuum cleaner if they are still wet or damp! Always wait until they
are thoroughly dry.
Cleaning your vacuum cleaner
To clean the outside parts of the product, use a fi ne cloth dipped in lukewarm water. Do not use aggressive
cleaning agents, paint thinners or solvents. Using these solutions could damage the surface of the product.
Copyright © 2014, Fast ČR, a.s.
Vacuum cleaner
3
4
5
4 Grill of the infl ow micro-fi lter
5 Infl ow micro-fi lter
6 Outfl ow H.E.P.A. fi lter
EN-8
6
Revision 10/2014