Sebson GS546 Mode D'emploi page 15

Attention:
Check the function of the smoke detector weekly!
Activation of the smoke detector (see Fig.7):
Attach the mounting ring to the back of the unit until it is fully engaged. Note: This requires a little more force. It is
recommended to fix the mounting ring to the ceiling with a screw beforehand.Then press and hold the TEST button
for about 3 seconds until the LED lights up and a short beep is heard. The smoke detector is now ready for
operation.
Functional check:
To check the function, keep the TEST button pressed for approx. 5s. The alarm tone sounds and the LED lights up
red. This is to check whether the electronics, the smoke detector's alarm unit and the battery are functioning. The
alarm tone stops immediately after releasing the TEST button.
Note: If neither the alarm sounds nor the LED flashes, the battery is may be empty or the device may be defective.
Replace it with a new functional device!
Temporary muting the Alarm
In the event of a false alarm, e.g. caused by heavy smoke development during cooking or high dust levels, the
alarm tone can be muted for approx. 10 minutes. It is essential to ensure that the alarm was not triggered by a fire!
To mute the alarm temporarily, press the TEST button. Then open doors and windows to clean the air. If after 10
minutes the air still contains a high number of combustion particles, the alarm will sound again. The mute function
can be repeated as often as required by pressing the TEST button. This function cannot be activated if there is
excessive smoke. To deactivate the mute function, press the TEST button!
Recurrent self-test of the smoke alarm detector on its function:
The smoke alarm detector performs every 30-40 seconds a self-test. You can see this by a short blink of the LED.
Explanation of the LED modes :
LED flashes every 40 seconds:
LED flashes every second and alarm sounds:
LED flashes every 8 seconds:
LED flashes every 40 seconds and a short
alarm tone sounds:
Installation (Fig.8) :
1: Dowel
2. Mounting ring
3. Holes for screws for fixing
4: Screw
5: Retainer of the bayonet connection
Attention:
Before drilling the mounting holes, make sure that there are no gas, electricity or water pipes at the
drilling location that could be damaged by this!
Attention
: The device is only ready for operation if the case is properly attached to the mounting base. Otherwise
the battery is deactivated and the smoke alarm is not ready for use.
The smoke alarm detector is working properly..
TEST button is pressed or the alarm has been triggered by
smoke.
The device is in the silent mode
Battery is low.
15