Table des Matières
Publicité
6.2.7 Multi-sequence ( M_FSt ) ............ P7
Available to program multi step operation in sequence.
oFF : Disable
6.2.8 Multi_1 : First angle in turn ( Frt.Ag) ............. P8
Angle setting for angle stop in turn from 0 to 9999 ( unit = 0.1 turn )
6.2.9 Multi_2 : Second reverse angle for next step of operation ( rEV.Ag ) ............. P9
Angle setting for angle stop in turn from 0 to 9999 ( unit = 0.1 turn )
6.2.10 Multi_3 : Holding time for next step of operation ( hLd.ti ) ............. P10
Time setting of holding to next step from 0 to 99 ( unit = 0.1 sec )
6.2.11 Display setting ( dSP.Md ) ............ P11
Display setting between two;
0 : speed setting
6.2.12 External I/O for remote control ( PLc.Md ) ............. P12
Available to use I/O for remote control. ( Remote start
oFF : Disable
6.2.13 Reverse torque control setting ( REvMd ) ............. P13
Reverse torque control can be selected between ON/OFF.
Factory setting password is " ON "
on : Stop by torque up
6.2.14 Screw type ( Scr.tP ) ............ P14
Screw type setting between two;
0 : Clockwise screw
6.2.15 Password setting ( PYord ) ............ P15
Setting new password.
on : Enable
1 : real time speed
on : Enable
off : Slip
1 : Counterclockwise screw
Factory setting password is " 0 "
- 16 -
Reverse
(pin4),
(Pin 8)
)
Publicité
Table des Matières
