Table des Matières
Publicité
6.2 Parameter setting
6.2.1 Driver model selecting ( ModEl ) ............ P1
Choose one of the right model number between 30n, 45n, 90n, 35n, 50n and 100n for
the connected screwdriver as below ;
YF30N
Model
YF30NP
Number
30n
[Caution] If wrong model selected, speed and torque can be different with it's spec.
6.2.2 Fastening speed ( F_SPD ) ............ P2
Change rotation speed for forward fastening.
Depend on the selected model, the min. and max. speed is automatically limited
according to the specification.
6.2.3. Loosing speed ( L_SPD ) ............ P3
Change rotation speed for reverse loosening.
Depend on the selected model, the min. and max. speed is automatically limited
according to the specification.
6.2.4 Soft start ( F_Acc ) ............ P4
The motor acceleration time to the target speed can be adjusted from 30 to 2000
seconds. It works as like soft start. The factory setting is 50mS.
[Caution] soft start feature can make different tightening torque for short screw or re-
tightening of already tightened screw.
6.2.5 Soft start for Reverse ( L_Acc ) ............. P5
The motor acceleration time to the target speed in Reverse rotation can be adjusted from
30 to 2000 seconds. The factory setting is 50 mS.
6.2.6 Multi-hit setting ( M_hit ) ............ P6
Number of torque up by clutch can be selected from 1 to 10 times.
Factory setting is 1 time.
YF45N
YF90N
YF45NP
YF90NP
45n
90n
- 15 -
YF35N
YF50N
PYF35N
PYF50N
YFA35N
YFA50N
35n
50n
YF100N
PYF100N
YFA100N
100n
Publicité
Table des Matières
